![]() ![]() ![]() Hopefully my carpenter lingo isn't too messed up for you and you can figure out what I'm doing. Not sure what to make the 2 rafter tie trusses out of either yet. End truss would have a post at 18' to support the ridge board. Roof trusses/joists would be resting on a RCDF 4x12x16' with an 8" heel. Ridge board probably a 2x16, but would need to check the length of the angle cut first. Was going with 2x12 since had no idea and nailed to a ridge board. Then would just have roof trusses/joists either 2' or 32" OC. Would have a tie at these locations based on somewhat you have shown. Would have 12"x12" RCDF as posts at 8' & 16'. It comes off of the house dining/living room areas. I can put supports in these where needed, so should be able to use 2x8's, but don't know where for sure to support them, as I cannot find a truss design aid with a ridge board that are hand framed. All roof trusses will be hand framed with a 2x12 ridge board. 2 are easier, as they are over the rooms with the RCDF ceiling joists with the wood decking for the ceiling. We have 3 spans that we are dealing with. So I have a set of prints that I cannot get any info off of, so I am trying to find where I can get dimensions for the spans we have with the pitch we have. He of course got mad, adjusted his bill and we parted ways. So I did one last time and he 'forgot' some more, so I called him out on it. We reminded him to look at the email on corrections and he got mad and said he didn't want to do emails anymore, just to call him. Was good for a bit, then his self showed up again. So I said I'd email him all the changes, so he could 'remember' them. Every time we'd give him what to do, he'd do a few of the changes/corrections, then we'd get the plan back and we'd have to tell him what he forgot. He wasn't cheap, but an acquaintance recommended him. We've been working on this project for about a year now. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |